home news forum careers events suppliers solutions markets expos directories catalogs resources advertise contacts
 
Solution Page

Solutions
Solutions sources
Topics A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
  Species
 

Recommendations for planting large soybean seed


East lansing, Michigan, USA
May 15, 2014

by Mike Staton, Michigan State University Extension

Large soybean seed may create some challenges. Understanding the challenges and the strategies for overcoming them will improve seed performance in 2014.

Soybean seed quality is very good this year. However, some of the seed is quite large at 2,100 to 2,400 seeds per pound. Seed size within a given variety can vary by as much as 20 percent and is determined by the environmental conditions occurring during the growing season. For a given variety, seed size does not affect the yield potential. However, the large seed may cause some management challenges for producers. Understanding these challenges and the strategies for overcoming them will improve seed performance in 2014.

The first step is to determine the size of the seed for each of your seed lots. The next step is to seek information from your operator’s manual, seed supplier and equipment dealer about equipping and setting your planter or drill to handle this year’s seed sizes. Taking these steps now will prevent problems at planting. Large seed – 2,400 seeds per pound or less – can be damaged by the fluted metering system in drills. This type of damage can be reduced by plugging every other feed cup and opening up the seed metering gates. Some drills allow the feed cup to be lowered, increasing the space between the fluted seed metering mechanism and the bottom of the feed cup. Check your operator’s manual for specific recommendations.

Another potential concern with large seed is that the seed may have enlarged so quickly last summer that it caused growth cracks in the seed coats. This is not a problem in 2014.

Large seed produces larger cotyledons (seed leaves) than small seed. The larger cotyledons are more difficult to lift out of the soil during emergence. This may cause emergence problems on fine-textured soils prone to crusting. Planting the seed in wide rows is usually beneficial as the soybeans are spaced closely enough within the row to crack the crust.

Also, consider planting slightly shallower and maintain residue cover over the row. In some cases, a timely rotary hoeing may be required to break the crust. Please see the Michigan State University Extension article “Improving soybean emergence on soils prone to crusting” at www.msue.msu.edu. The loss of one cotyledon on a few plants during emergence will not affect yield. However, if a large percentage of plants lose one or both cotyledons, yields will be significantly reduced.

All soybean seed must imbibe 50 percent of its weight in water during germination. Large soybean seed must imbibe more water to germinate than small seed. This may lead to delayed or uneven emergence under marginal soil moisture conditions. Most agronomists recommend planting soybean seed into at least 0.5 inches of moist soil to promote uniform germination and emergence. This recommendation is even more important with large soybean seed.

This article was produced by the SMaRT project (Soybean Management and Research Technology). The SMaRT project was developed to help Michigan producers increase soybean yields and farm profitability. SMaRT is a partnership between MSU Extension and the Michigan Soybean Checkoff program.

This article was published by Michigan State University Extension.
For more information, visit
http://www.msue.msu.edu.  
To contact an expert in your area, visit
http://expert.msue.msu.edu, or call 888-MSUE4MI (888-678-3464).



More solutions from: Michigan State University


Website: http://www.msu.edu

Published: May 16, 2014


Copyright @ 1992-2024 SeedQuest - All rights reserved